wholesale christmas jewelry bulk Method of handmade lanterns
3 thoughts on “wholesale christmas jewelry bulk Method of handmade lanterns”
Leave a Comment
You must be logged in to post a comment.
wholesale christmas jewelry bulk Method of handmade lanterns
You must be logged in to post a comment.
nice jewelry boxes wholesale Making tutorials for lantern:
Medic materials required for homemade lanterns:
In required materials: cardboard, stopper knife, straight ruler, pencil, double -sided glue, line, line rope.
Making steps:
1. Prepare a rectangular red card paper (I use an expired old month card) to make a beautiful little lantern.
2. Leave 0.5 ~ 1.0cm on each side of the stuck paper, divide several parallel lines according to the equal division, and then cut it with a stopper knife.
3, roll the card paper arc.
4. Paste the corner, cut into thin strips as spikes, and then stick to the line rope.
5, the beautiful little lantern is just fine.
is actually very simple.
wholesale body piercing jewelry china 00:00 / 01: 0670% shortcut keys: Play / suspend ESC: exit full screen ↑: increased by 10% ↓: decreases by 10% →: Single fast forward 5 seconds studio Here you can drag no longer appear in the player settings to reopen the small window shortcut key description
brass choker wholesale jewelry making Pay content for time limit to check for freenAnswer paper lantern templates: making materials: cardboard (red, gold), gold wire thread, gold paint pen, embroidered needle, scissors, hot melting rubber guns and rubber sticks, 5mm beads in diameter 2: Make a golden silk line tassel (an tassel production process attached to the tail of the article) Step 3: Cut out the red card paper of the lantern according to paper, and use the golden paint pen to draw the golden edge line step 4: Use scissors to light the light petals on the edge of the scissors. Rolling inwardly inwardly 5: Cut on a thin gold card paper, bend into the center step of the lantern petals 6: Put the pre -made golden wire streams into the center of the lantern petals, and the fixed steps on the inside 7 7 : Paste the tip of the petals of each petal lantern. Paste the paste. : Scene into a 25cm long coil step 2: Fold the wire wire, knotting it at 6cm, so as to form a ring step 3: The lower end of the ring ring is tied to the center of 25cm. Step 4: Cut it 4: Cut At the end of the coil, the folding line step 5: Tie up again at 1.2cm at the top of the folding. Finally, put the line head into the center center of the stream Soviet end.